Reload command in Cisco WSA

Todays lesson is about the reload-command. Yes, there is a reload-command in CLI of the Ironport Web Security Appliance. There are only two facts that is good to know about the command. One good thing and one bad thing.

Good thing: when pressing enter after the reload command you get prompted “Are you sure? y/N”

Bad thing: the reload command wipes the configuration and does a total factory reset.

Take away from todays lesson: read the warnings before entering that Y-key!

Posted in Uncategorized
2 comments on “Reload command in Cisco WSA
  1. Hi there! I simply wish to give a huge thumbs up for the good information you’ve gotten right here on this post. I will likely be coming back to your blog for extra soon.

  2. Shahid says:

    There is a reload and a reboot command. Reload command will wipe all the config but reboot will just powercycle the device and keep the configurations.

Leave a Reply

Your email address will not be published. Required fields are marked *



[mc4wp_form id="2457"]
Website Security Test